Charging the battery pack, To remove the battery pack, Charging time – Sony CCD-CR1 User Manual
Page 11
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Charging the battery pack
Charge the battery pack on a flat surface without vibration. The supplied battery pack
NP-FIO is charged a little at the factory. To charge the battery pack, use the supplied
AC-VFIO AC adaptor/chargcr.
(
1
)
Fit and slide the battery pack in the direction of the arrow,
(
2
)
Connect the power cord to the AC adaptor/charger and a wall outlet. The
CHARGE lamp (orange) lights up. Charging begins.
When the CHARGE lamp goes out,
normal charge is completed. For full charge,
which allows you to use the battery longer than usual, leave the battery pack attached
for about 1 hour after normal charge is completed.
o
To remove the battery pack
Slide the battery pack in the direction of the arrow.
Charging time
When using the NP-FIO rechargeable battery pack:
Charging time*
143 (H.'
t
) minuk's
The number in parentheses indicates the time when you use a normally charged
battery.
* Approximate minutes to charge an empty battery pack using the supplietl charger.
(Lower temperatures require a longer charging time.)
ir