Sony CCD-CR1 - Manual (Page 8)

Installing the batteries
Before using your camcorder, you first need to install two size AA (LR6) Sony batteries
or the charged battery pack. Use the supplied size AA (LR6) Sony batteries or the NP-
I'lO "InfoLlTHlUM ' battery pack {S seríese).
When vou install or remove the batteries, be sure to turn off the camcorder to prevent
misoperation of the camcorder.
Vou can also use house current as a power source. (P. 10)
(1) To opon the lid of the battery compartment, slide the OPEN (ВАТТ) release
lever at the bottom of the camcorder to the left, then slide it toward you and
release.
( 2 ) install two size AA (LR6) batteries or the battery pack in the direction of the
arrow. Then close the lid and slide it until it clicks.
Note on size AA (LR6) batteries
• Ik’ sure to install two si/e AA (LR6) batteries with correct polarity.
• Vou can not use si/i’ AA (LRh) batteries in a cold environment. Use the NP-RO battery
pack .
Battery life
When using two size AA (LRh) Sony batteries or the NP-FIO rechargeable battery pack:
Battery Size AA (LR6) batteries NP-FIO
Continuous recording W) miniitt.-^ 40 {80} minutes
time*
Typical recording time** .'^0 mnuitt's .SO (4.S) minutes
Playing time on LCD hO iTumik''' 90 (80) minutes
\umbors in parentheses of NP-RO indicate the time when you use a normaffy charged
batterw
* Approximate cc>ntinuous recording time at 77°F (25°C). Battery life will be shorter if
you use the camcorder in a cold environment.
Approximate minutes when recording while you repeat recording start/stop and
turning the power on/off. The actual battery life may be shorter.