Sony CDP-CX350 - Manual (Page 4)

Getting Started
Unpacking
Chock tliat \4ui roooivod iho following iloms;
• Audio cord (1)
• CD booklet holders (3) and label (!)
• Remote commander (remote) (1)
• Size AA (LR6) batteries (3)
How to use the CD booklet holder
The CD booklet holder helps you locate discs easih'.
After vou ha\’o inserted discs into the pla\’or, \ ou can put
the CD booklet (which comes with a CD) into the
supplied holder. Put two CD booklets facing back to back
into a pocket. Stick (lie number label on each pocket,
matching the number of the disc slot u here you ha\ e
inserted the disc. You can put up to 300 CD booklets into
the holders.
Inserting batteries into the remote
You can control the player using the supplied remote.
Insert three size AA (LR6) batteries (supplied) by
matching the + and - ends on the batteries to the
diagram inside the battery compartment.
Insert the negative (-) end first, then push in and down
until the positive (+) end clicks into position.
When using the remote, point it at the remote sensor S
on the player.
If <Xi flashes in the remote's display, replace all the
batteries with new alkaline batteries. Use of battery types
other than alkaline batteries, such as manganese
batteries, may not last longer than the alkaline batteries.
The loaded memory in the remote will be retained for a
few minutes while you replace the batteries.
Notes
• Do not leave the remote near an extremely hot or humid
place.
• Do not drop any foreign object into the remote casing,
particularly when replacing the batteries.
• Do not expose the remote sensor to direct sunlight or leave
too near lighting apparatuses. Doing so may cause a
maltunction.
• If you do not use the remote for an extended period of time,
remove the batteries to avoid possible damage from battery
leakage and corrosion.
Hooking Up the System
Overview
This section describes how to hook up the CD player to
an amplifier. Be sure to turn oft the power of each
component before making the connections.
CONTROLAI II
DIGITAL OUT
(OPTICAL)
What cords will I need?
Audio cord (1) (supplied)