Cisco MICA V110 - Manual (Page 7)

show Command Examples
Basic V110 for MICA Modems on Cisco Access Servers 7
Reason (=0 ): no disconnect has yet occurred
Parameter #1 Connect Protocol: ISDN Mode
Parameter #2 Compression: None
Parameter #3 EC Retransmission Count: 0
Parameter #4 Self Test Error Count: 0
Parameter #5 Call Timer: 37079 secs
Parameter #6 Total Retrains: 0
Parameter #7 Sq Value: 7
Parameter #8 Connected Standard: V.110
Parameter #9 TX,RX Bit Rate: 9600, 9600
Parameter #11 TX,RX Symbol Rate: 0, 0
Parameter #13 TX,RX Carrier Frequency: 0, 0
Parameter #15 TX,RX Trellis Coding: (n/a), (n/a)
Parameter #16 TX,RX Preemphasis Index: 0, 0
Parameter #17 TX,RX Constellation Shaping: (n/a), (n/a)
Parameter #18 TX,RX Nonlinear Encoding: (n/a), (n/a)
Parameter #19 TX,RX Precoding: (n/a), (n/a)
Parameter #20 TX,RX Xmit Level Reduction: 0, 0 dBm
Parameter #21 Signal Noise Ratio: 0 dB
Parameter #22 Receive Level: 0 dBm
Parameter #23 Frequency Offset: 0 Hz
Parameter #24 Phase Jitter Frequency: 0 Hz
Parameter #25 Phase Jitter Level: 0 degrees
Parameter #26 Far End Echo Level: 0 dBm
Parameter #27 Phase Roll: 0 degrees
Parameter #28 Round Trip Delay: 0 msecs
Parameter #30 Characters transmitted, received: 247, 308
Parameter #32 Characters received BAD: 0
Parameter #33 PPP/SLIP packets transmitted, received: 9, 9
Parameter #35 PPP/SLIP packets received (BAD/ABORTED): 0
Parameter #36 EC packets transmitted, received OK: 0, 0
Parameter #38 EC packets (Received BAD/ABORTED): 0
Parameter #39 Robbed Bit Signalling (RBS) pattern: 0
Parameter #40 Digital Pad: (n/a), Digital Pad Compensation: None
Parameter #41 V110 frames received bad: 0
Parameter #42 V110 frames received good: 7417301
Parameter #43 V110 frames transmitted: 7417310
Parameter #44 V110 sync lost: 0
show modem log
Fields that have been added or changed for this command are:
Connect Protocol: ISDN Mode
Connected Standard V.110
V110 frames received bad:
V110 frames received good:
V110 frames transmitted:
V110 sync lost:
The show modem log command example is as follows:
router# show modem log 1/1
Modem 1/1 Events Log:
...
...
...
4d06h :Modem State event:
State: Train Up
4d06h :Modem State event:
State: EC Negotiating
4d06h :Modem State event: