Cisco MICA V110 - Manual (Page 5)

show Command Examples
Basic V110 for MICA Modems on Cisco Access Servers 5
http://www.cisco.com/univercd/cc/td/doc/product/software/ios120/12cgcr/dial_r/drprt1/dr
modmgt.htm#xtocid10451223
See also show modem at:
http://www.cisco.com/univercd/cc/td/doc/product/software/ios113ed/113aa/113aa_2/58cfe
ats/c5800uas.htm#19600
•
show modem log
http://www.cisco.com/univercd/cc/td/doc/product/software/ios120/12cgcr/dial_r/drprt1/dr
modmgt.htm#xtocid10451261
•
show modem configuration
http://www.cisco.com/univercd/cc/td/doc/product/software/ios120/12cgcr/dial_r/drprt1/dr
modmgt.htm#xtocid10451239
•
show modem connect-speeds
http://www.cisco.com/univercd/cc/td/doc/product/software/ios120/12cgcr/dial_r/drprt1/dr
modmgt.htm#xtocid10451245
•
show modem operational-status
http://www.cisco.com/univercd/cc/td/doc/product/software/ios120/12cgcr/dial_r/drprt1/dr
modmgt.htm#xtocid10451279
For the commands above, MICA Modem Management code has been modified to display the correct
information for V.110 associated Connect Protocol and Connected Standard. In addition, the correct
line speeds for V.110 related Bearer Rates have also be added to commands that display the
information.
For other and related modem management commands, such as modem-at mode, see:
http://www.cisco.com/univercd/cc/td/doc/product/software/ios120/12cgcr/dial_r/drprt1/drmo
dmgt.htm#xtocid104510
show Command Examples
The show modem command includes outputs for the show modem configuration command and
the show modem connect-speeds command.
show modem
Fields that have been added or changed for this command are:
Modem Type V.110
Protocol: ISDN Mode
Connection Speeds 34000
The show modem command example is as follows:
router# show modem 1/0
Mdm Typ Status Tx/Rx G Duration RTS CTS DCD DTR
1/0 V.110 Conn 9600/9600 0 10:12:19 x x x x
Modem 1/0, Mica Hex Modem (Managed), Async1, TTY1
Firmware Rev: 2.7.0.6
Modem config: Incoming and Outgoing
Protocol: ISDN Mode, Compression: None
Management config: Status polling
RX signals: 0 dBm