Troubleshooting, There is no sound, The cd does not play – Sony CDP-CX53 User Manual

Page 18: The remote does not function, The player functions incorrectly, Specifications, Additional information

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Additional Information

Troubleshooting

If you experience any of the following difficulties while
using the player, use this troubleshooting guide to help
you remedy the problem. Should any problem persist,

consult your nearest Sony dealer.

There is no sound.

"►Check that the player is connected securely.

•■►Make sure you operate'the amplifier correctly.

The CD does not play.

■►There is no CD in a slot ("no dISC" appears).

Insert a CD.

■►Insert the CD with the label side facing right.

■►Clean the CD (see page 17).
■►Moisture has condensed inside the player. Open

the front cover and leave the player turned on
for about an hour (see page 17).

The remote does not function.

■►Remove obstacles in the path of the remote and

the player.

■►Point the remote at the remote sensor H on the

player.

■►Replace all the batteries in the remote with new

ones it they are weak.

■►Set the CDl / 2 / 3 switch on the remote

according to the position of the COMMAND

MODE selector displayed in the front panel
display (see page 5).

The player functions incorrectly.

■►The microcomputer chips may be operating

incorrectly. Disconnect the AC power cord, then
connect it back to the wall outlet to reset the

player.

Specifications

Compact disc player

Laser

Semiconductor laser (A. = 780 nm)
Emission duration: continuous

Laser output

Max 44.6
* This output is the value measured at

a distance of 200 mm from the
objective lens surface on the Optical
Pick-up block with 7 mm aperture.

Frequency response

2 Hz to 20 kHz ± 1 dB

Signal-to-noise ratio

More than 100 dB

Dynamic range

More than 88 dB

Harmonic distortion

Less than 0.013 %

Channel separation

More than 95 dB

Output

Jack
type

Maximum Load impedance
output
level

LINE OUT Phono

jacks

2 V Over 10 kilohms
(at 50 kilohms)

DIGITAL Optical
OUT output
(OPTICAL) connector

- 18 dBm Wave length: 660 nm

General
Power requirements

Where purchased

Power requirements

USA/Canada

120 V AC, 60 Hz

Australia

240 V AC, 50 Hz

Europe

220 V-230 VAC, 50/60 Hz

Other countries

no V -120 V or 220 V - 240 V
AC, adjustable, 50/60 Hz

Power consumption

12 W

Dimensions (approx.)
(w/h/d)

When the front cover is closed*
430

X

182.5

X

295

mm

(17 x 7 1 /4

X

11 5/8 in.) incl. projecting parts

When the front cover is open
430

X

182.5

X

414

mm

(17 x 7 1 /4

X

16 3/8 in.) incl. projecting parts

Mass (approx.)

5.2 kg (11 lbs 8 oz)

18

Supplied accessories

Audio cord (2 phono plugs - 2 phono plugs) (1)
CONTROL A1 cord (supplied for Canadian models only) (1)
Remote commander (remote) (1)
Sony SUM-3 (NS) batteries (2)
CD booklet holder (1)
Label (1)

Design and specifications are subject to change without notice.

Advertising