Sony LBT-S3000 - Manual (Page 8)

2
Press TUNING MODE repeatedly
until "AUTO" appears in the
display.
3
Press TUNING+/-.
The frequency indication changes and
scanning stops when the system tunes in
a station. "TUNED" and "STEREO" (for
a stereo program) appear.
step 3: Presetting radio stations
(continued)
Press TUNER MEMORY.
The next available preset number flashes
in the display. The stations are stored
from preset number 1.
5
Press ENTER/NEXT.
The station is stored.
6
Repeat steps 1 through 5 to store
other stations.
To tune in a station with a weak
signal
i’ress TUNING MODE ropoatedlv until
"MANUAL" appears in step 2, then press
TUNING +/- to tune in a station.
To store another station on an
existing preset number
Start over from step 1. After step 4, press
TUNING +/- to select the preset number on
which you \vant to store the station.
You can add a new preset number after the
last preset number.
To erase a preset number
1 Press and hold TUNER MEMORY until the
preset number flashes in the display.
2 Press TUNING +/- to select the preset
number you want to erase. Select "ALL
ERASE" to erase all preset numbers.
3 Press ENTER/NEXT.
When you erase a preset number, all the
following preset numbers shift up and reduce
by one.
To change the AM tuning interval
(for models with the AM TUNING STEP
switch on the rear panel)
The AM tuning interval is factory-preset to
9 kHz (10 kHz in some areas). To change the
AM tuning interval, turn off the system and
set the AM TUNING STEP switch on the rear
panel to 10 kHz (or 9 kHz). Then turn the
system back on. When you change the
interval, all the preset stations will be erased.
Note
The preset stations are canceled when you
disconnect the power cord or if a power failure
occurs for more than half a day.
8