Using the remote commander, Set power on the camcorder as follows – Sony CCD-FX410 User Manual
Page 22
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Using the Remote Commander
J
By using the Remote Commander, you can be in the picture with your friends and family,
or conveniently control the playback of your tape from a distance.
1
Insert two size AA (R6) batteries with
correct polarity.
Set m REMOTE COMMANDER
ON/OFF on the battery mounting
surface of the camcorder to ON.
If the battery is attached, remove it.
Reattach the battery after setting the
REMOTE COMMANDER ON/OFF switch.
Set POWER on the camcorder as follows:
— When camerarecording, 1) press the small green button on POWER and slide
POWER to CAMERA, 2) turn STANDBY up.
— When playing back, slide POWER to VTR.
Point the Commander to the remote sensor of the camcorder and press
the appropriate button on the Commander.
Remote sensor
2 m (6.6 ft)
(Approximate maximum distance and angles for remote control)
Note on the Remote Commander
• Keep the remote sensor away from the strong light source such as direct sunlight or
illumination. Remote control with the Commander may not be effective.
• The command mode of the Commander is VTR2. Avoid to use the Sony VCRs with the
same command mode at the same time.
22
Basic Camera Operation