Sony LBT-D270 - Manual (Page 6)

Inserting the Batteries Setting the Clock
Install two size AA (R6) batteries in the
supplied for remote control.
1
Open the lid.
2
Insert two R6 (size AA) batteries.
.Match the + and - to the diagram in the
battery compartment.
i3 Close the lid.
Battery life
You can expect the remote control to
operate tor about six months (using Sony
SLM-a (\S) batteries) before the batteries
run down. Wlien the batteries no longer
('perate the remote, replace all the batteries
with new onec.
To avoid battery leakage
If you are not going to use the renjote for a
long time, remoye the batteries to avoid
damage caused by corrosion from battery
leakage.
The built-in clock shows the time in the
display.
2,4
5
Press ENTER/NEXT.
The clock starts running and the upper
dot flashes. Use the time signal to set the
clock accurately. The upper dot flashes
for the first half of a minute (0 to 29
seconds), and the lower dot flashes for
the last half of a minute (30 to 59
seconds).
3,5
■ DISPLAY/
DEMO
To check the time
Press DISPLAY/DEMO a few times.
The current time appears for a few seconds.
To correct the clock setting
Repeat steps 1 to 5.
1
Press CLOCK SET.
The "AM" and hour indication begin
flashing.
flashing
2
Set the current hour by pressing ◄ or ►
(CURSOR CONTROL) until the correct
hour appears.
flashing
3
I’ress ENTER/NEXT.
Tlie minutes indication begins tlnshing.
4
Set the current minute by pressing ◄ or
► until the correct minute appears.
Chapter 1: Setting Up