Sony STR-DE905G - Manual (Page 18)

Preparing and Using the Remote
When programing the IR code, point the remote
at the IR sensor on the receiver from a distance no
greater than 4 inches (10 cm) and hold down the
button on the remote for about 5 seconds until the
instruction "RELEASE YOUR COMMANDER"
appears.
IR sensor
Keep the remote pointed horizontally at the IR
sensor until the code is programed.
If you tilt or move the remote during the
programing process, the IR code may not be
programed correctly.
Repeat this procedure for the remaining buttons
that appear on the TV screen. If an IR code was
not programed correctly, the IR code setting
indicator will flash.
If your TV set's remote has an independent input
selector button (e.g., VIDEO 1)
Program the 1« code of this button when the VIDEO 1
button appears When you turn on the receiver, the T\'
su'itclies to the video input auti>matically.
If your TV set does not have an independent input
selector button or has a cyclic input selector button
Click EXIT to return to the main menu.
The TV's input can not be switched automatically when
you turn on the receiver Sw’itch the TV to the video
input manually. If vou programed an IR code for the
VIDEO 1 button, follow the instructions in "To erase a
specific IR code" below to erase the VIDEO 1 code.
To erase TV IR codes
Click CODE CLEAR.
• To erase a specific IR code
] Click SINGLE IR CODE CLEAR
2 Click the button you want to clear.
"Are you sure?" appears for confirmation.
3 Click YES to erase the code.
"CODE CLEAR!" appears in the display.
To stop before erasing a code, click NO.
To erase another code repeat steps 2 and 3.
• To erase all the TV IR codes
1 Click TV IR CODE CLEAR.
"Are you sure?" appears for confirmation.
2 Click YES to erase the codes.
"CODE CLEAR!" appears in the display. To stop before
erasing the codes, click NO.
• To erase all the IR codes.
1 Click ALL IR CODE CLEAR.
"Are you sure?" appears for confirmation.
2 Click YES to erase the codes.
"CODE CLEAR!" appears in the display. To stop before
erasing all the codes, click NO.
Note
Some IR codes may not hav’e been successfully programed,
even if "RELEASE YOUR COMMANDER" appears on the
TV screen. In this case, try programing the IR code again. If
the IR code still cannot be programed, follow the procedure
described in "Programming Other Infrared (IR) Codes
{USER IR setting)" on page 22.
To change from another manufacturer's TV set to a Sony
TV set
Connect the receiver's MONITOR OUT jack to the VIDEO 1
input jack of the Sony TV set. Follow steps 1 to 3, then click
SONY TV in step 4. Click VIDEO I 2 3 and/or WIDE to
specify VIDEO 1 and/or WIDE if necessary. Then click
RETURN or EXIT.
To exit to the main menu
Click EXIT,
To return to a previous menu
Click RETURN,
18