Sony CCD-TRV41 - Manual (Page 21)

Searching for the end of the picture
You can go to the end of the recorded portion after you record and play back the tape to
make the transition between the last scene you recorded and the next scene smooth.
The tape starts rewinding or fast-forwarding and the last 5 seconds (10 seconds in LP
mode) of the recorded portion play back. Then the tape stops at the end of the recorded
picture
(End Search).
Note that the End Search function does not work once you eject the cassette after you
have recorded on the tape.
( 1 ) While pressing OPEN, open the LCD panel.
(2) Press END SEARCH.
This function works when the POWER switch is set to either CAMERA or VTR.
I
V
I
If you start recording after using END SEARCH
Occasionally, the transition between the last scene you recorded and the next scene may
not be smooth.
Advanced operations
Using alternative power sources
You can choose any of the following power sources for your camcorder: battery, pack,
the house current and alkaline battery. Choose the appropriate power source
depending on where you want to use your camcorder.
Place Power source Accessory to be used
Indoors House current Supplied AC power adaptor
Outdoors Battery pack Battery pack NP-F530 (supplied),
NP-F730
Size AA (LR6) Sony Alkaline battery Battery case (supplied)
Note on power sources
Disconnecting the power source or removing the battery pack during recording or
playback may damage the inserted tape. If this happens, restore the power supply
again immediately.