Warning indicators, To watch the demonstration, To enter demo mode – Sony CCD-TRV41 User Manual
Page 85: To exit demo mode
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Warning indicators
If indicators flash in the viewfinder or in the display window, check the following:
J'-. you can hear the beep sound when the BEEP is set to ON.
5min
Omin
"X~
"X
-'¿1-
|T] The battery is weak or dead.
Slow flashing: The battery is weak.
Fast flashing: The battery is dead.
[
2
] The tape is near the end.
The flashing is slow.
The tape has run out.
The flashing becomes rapid.
[
4
] No tape has been inserted.
[
5
] The tab on the tape is out (red).
Moisture condensation has occurred.
[
7
] The video heads may be contaminated.
This indicator appears only on the
viewfinder.
[8] Some other trouble has occurred.
Disconnect the power source and contact
your Sony dealer or local authorized
facility.
[
9
] The lithium battery is weak or is not
installed.
To watch the demonstration
You can watch a brief demonstration of pictures with special effects. If the
demonstration appears when you turn on the camcorder for the first time, exit the
Demo mode to use your camcorder.
To enter Demo mode
(1) Eject the cassette and set the POWER switch to OFF.
(2)
Turn STANDBY up.
(3)
While holding down t>, set the POWER switch to CAMERA. The
' demonstration starts. The demonstration stops when you insert the cassette.
Note that once you enter Demo mode, this mode is retained as long as the lithium
battery is in place. Therefore, demonstration starts automatically 10 minutes later every
time you set the POWER switch to CAMERA, and after you eject the cassette.
To exit Demo mode
(1)
Set the POWER switch to OFF.
(2)
Turn STANDBY up.
(3)
While holding cdown □, set the POWER switch to CAMERA.