Troubleshooting, There's no sound, The cd does not play – Sony CDP-CE315 User Manual

Page 18: The player functions incorrectly, Supplied accessories, Specifications, Additional information

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Additional information

Troubleshooting

If you experience any of the following difficulties while
using the player, use this troubleshooting guide to help
you remedy the problem. Should any problem persist,
consult your nearest Sony dealer.

There's no sound.

"►Check that the player is connected securely.
^Make sure you operate the amplifier correctly.
^Adjust the playback level using the LINE OUT

LEVEL +/-buttons on the remote (CDP-CE315
and CDP-C260Z only).

The CD does not play.

■^There's no CD inside the player ("no dISC"

appears). Insert a CD.

^Place the CD with the label side up on the disc

tray correctly.

■^Clean the CD (see page 17).
^Moisture has condensed inside the player.

Remove the disc and leave the player turned on
for about an hour (see page 17).

"►Place the CD in the correct position on the disc

tray.

The remote does not function. (CDP-CE315 and CDP-

C260Z only)

^Remove the obstacles in the path of the remote

and the player.

"►Point the remote at the remote sensor M on the

player.

^Replace aU the batteries in the remote with new

ones if they are weak.

The player functions incorrectly.

^The microcomputer chips may be operating

incorrectly. Turn the power off, then turn it

back on to reset the player.

Specifications

Compact disc player

Laser

Semiconductor laser (k = 780 nm)
Emission duration: continuous

Laser output

Max 44.6 |iW*

* This output is the value measured at

a distance of 200 mm from the
objective lens surface on the Optical
Pick-up block with 7 mm aperture.

Frequency response

2 Hz to 20 kHz ± 0.5 dB

Signal-to-noise ratio

More tlian 102 dB

Dynamic range

More than 98 dB

Harmonic distortion

Less than 0.0045%

Output

Jack

type

Maximum Load

output impedance

level

LINE OUT

Phono

jacks

2 V Over 10 kilohms

(at 50 kilohms)

DIGITAL OUT

Optical

(OPTICAL)

output

(European

coimector

models only)

-ISdBm Wave length: 660nm

General

Power requirements

Where purchased

Power requirements

Canada

120 V AC, 60 Hz

Europe and some Asian

countries

220 V - 230 V AC, 50/60 Hz

Other countries

110 V -120 V or 220 V - 240 V AC,

adjustable, 50/60 Hz

Power consumption

14 W

Dimensions (approx.)

(w/h/d)

430 X 120 X 385 nun
(17

X

4 3/4 X 151/4 in.) incl, projecting

parts

Mass (approx.)

5.4 kg (11 lbs 15 oz)

Supplied accessories

Audio cord (2 phono plugs - 2 phono plugs) (1)
Remote commander (remote) (1) (CDP-CE315 and CDP-
C260Z only)

Sony SUM-3 (NS) batteries (2) (CDP-CE315 and CDP-
C260Z only)

Design and specifications are subject to change without notice.

1 8

EN

Advertising