Sony STR- D915 - Manual (Page 18)

I Chapter 3 Advanced Operations
Recording an Audio Source
Editing a Video Source
Recording on a Tape
You can record and make copies of audio program sources
on a tape, DAT or MD using the receiver. See your tape
deck, DAT deck or MD recorder’s instruction manual if you
need help.
¡■yrgsfcir V ■■ -m-iv.-i
■=t> Audio signal flow
1 Press a function button to select the
recording source.
2
Set the recording source to be ready for
playback.
For example, tune in the desired station for an FM/
AM broadcast.
3
Insert a blank tape into the recording deck
and adjust the recording level, if necessary.
4
Start recording on the recording deck and
then start playing the recording source.
Note
When you record on a DAT deck or MD recorder coimected
to the DAT/MD RFC OUT jacks, the sound field and low
boost settings have no effect on recording.
You can monitor the sound being recorded on a
tape
If you have connected a 3-head tape deck to the TAPE
MONITOR jacks, press TAPE MONITOR while recording or
dubbing, so that the TAPE MONITOR indicator lights up
and you can monitor the recording results. To listen to the
source sound, press the button again until the indicator goes
off.
Recording on a Video Tape
You can record and make copies of programs from other
VCR, LD player or TV using the receiver. See your VCR, LD
player or TV’s instruction manual if you need help.
’ Signal flow
STR-D915 only
1
Press a function button to select the
recording source.
Set the recording source to be ready for
playback.
For example, insert a source tape you want to record
from into the playback VCR.
3
Insert a blank video tape into the recording
VCR.
4
start recording on the recording VCR and
then start playing the recording source.
18