Receiving fm/am broadcasts, Direct access tuning, 1 press tuner – Sony 3-753-022-22(1) User Manual
Page 3: 2 select fm or am, 3 press direct tuning, 5 adjust the volume, 2 select fm, 3 press + or-tuning, 4 adjust the volume, Example 1: fm 108.00 mhz example 2: am 1350 khz
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
L
Receiving FM/AM Broadcasts
How to receive a broadcast
When you know the
frequency
See "Direct Access Tuning".
When you do not know
the frequency
FM: See "Automatic Tuning".
AM: See "Manual Tuning".
Tuning in a preset
frequency
See "Preset Tuning".
Direct Access Tuning
POWER — ON
4 2 3
Ip all
I CTT 3
i
3
OD ®
Select
SPEAKERS '
A or B.
1
Press TUNER.
2
Select FM or AM.
3
Press DIRECT TUNING.
4
Press the appropriate numeric buttons to enter
the frequency.
(See examples below.)
5
Adjust the volume.
Automatic Tuning (for FM reception)
Select SPEAKERS
A or B.
1
Press TUNER.
2
Select FM.
3
Press + or-TUNING.
When a station is received, automatic tuning stops
automatically. To change the station, press + or -
again.
4
Adjust the volume.
When sweeping does not stop at the desired station
The signal strength is weak. Tune in the station as described in
“Direct Access Tuning”.
Example 1: FM
108.00
MHz
Example 2: AM 1350 kHz
For entering AM frequencies
You do not need to enter the last "0".
Correcting the entered frequency
Repeat the above steps from the beginning.
If the frequency figures flash in the display window
The entered number is outside the receiver's frequency range (FM
87.5 to 108 MHz; AM 530 to 1710 kHz).
Enter the correct frequency.