Specifications, Audio power specifications, Power output and total harmonic distortion – Sony 3-753-022-22(1) User Manual
Page 12: Other specifications, Amplifier section, General
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Specifications
Audio Power Specifications
POWER OUTPUT AND TOTAL HARMONIC DISTORTION
With 8-ohm load, both channels driven, from 40 - 20
kHz, rated 40 watts per channei minimum RMS power,
with less than 0.8% total harmonic distortion from 250
milliwatts to rated output.
Tuner section
Other Specifications
Amplifier section
Continuous RMS power output (8 ohms, at 1 kHz less than
0.8% total harmonic distortion)
50 W + 50 W
Dynamic power (at 1 kHz IHF)
55 W + 55 W (8 ohms)
60 W + 60 W{4 ohms)
Harmonic distortion
Less than 0.8% at rated output
Frequency response
PHONO: RIAA equalization curve ±0.5 dB
CD
VIDEO
TAPE
10 Hz ■ 50 kHz " ° dB
Inputs
Sensitivity
Impedance
S/N (weighting
network, input level)
PHONO
2.5 mV
50 kilohms
74 dB
72 dB* (A, 2.5 mV)
CD
VIDEO
TAPE
150 mV
50 kilohms
95 dB
80 dB* (A. 150 mV)
78 IHF
Outputs
REC OUT, VIDEO
(AUDIO) OUT
Voltage 150 mV
Impedance 10 kilohms
SPEAKER A, B
Accepts speakers of
8-16 ohms
HEADPHONES
Accepts low and high
impedance headphones
Tone controls
BASS; ±10 dB at 100 Hz
TREBLE; ±10 dB at 10 kHz
Muting
-20 dB
DBFB
+ 12 dB at 70 Hz
FM tuner section
AM tuner section
Tuning range 87.5 — 108 MHz
530 — 1710 kHz
Antenna
terminals
300 ohms,balanced
75 ohms, unbalanced
External antenna
terminal
Sensitivity at
50 dB
quieting
18.3 dBf, 4.5 (iV
(mono)
38.3 dBf, 45 H.V
(stereo)
—
Usable
sensitivity
11.2 dBf, 2 nV (IHF)
Loop antenna:
500 trV (at 1,000 kHz)
Signal-to-
noise ratio
76 dB (mono)
70 dB (stereo)
54 dB (at 50 mV/m)
Harmonic
distortion
0.3% (mono), 0.5%
(stereo) at 1 kHz
0.5% (at 50 mV/m,
400 Hz)
Selectivity
60 dB at 400 kHz
40dBat 10 kHz
Separation
45 dB at 1 kHz
—
Frequency
response
30 Hz —15 kHz
dB
—
General
System
Tuner section: PLL quartz-locked digital
synthesizer system
Preamplifier section; low-noise NF type equalizer amp
Power amplifier section: quasi-complementary SEPP
Power requirements
120 V A C , 60 Hz
Power consumption
90 W
In standby condition: 5 W
AC outlets
One switched (120 W/1A Max.)
Dimensions
Approx. 430
X
122.5 x 300 mm (w/h/d)
(17 X 4 7g X 11 Vg inches)
including projecting parts and controls
Weight
Approx. 6.5 kg (14 lb 5 oz)
Accessories supplied
FM wire antenna (1)
AM loop antenna (1)
Remote Commander RM-S103 (1)
Sony batteries SUM 3(NS) (2)
Design and specifications subject to change without notice.