Sony 3-755-967-11(1) - Manual (Page 17)

Manual Tuning
How to use the supplied SW compact antenna
Usually the telescopic antenna is sufficient for SW reception.
However, in a metal or concrete building, the use of the supplied
SW compact antenna (AN-71) is recommended.
1 Fully pull out the cord from the case.
2 Attach the coupler to the telescopic antenna.
3 When the window can be opened: Extend the cord and the
case out through the window, after making sure there is no
danger.
When the window cannot be opened: Fully extend the cord
along the frame of the window.
Using an external antenna for MW and SW reception
Use the wide range antenna AN-1 or AN-102 (not supplied).
1 With a connecting cord, connect the OUTPUT jack of the
antenna controller and the INPUT jack of the antenna coupler
(supplied with the AN-1 or AN-102).
32
2 For MW: Put the antenna coupler near the ICF-SW33.
For SW: Attach the antenna coupler to the telescopic antenna.
’ Antenna coupler for SW
AN-1
Antenna coupler for MW
Note
For further details, refer to the instruction manual of the AN-1 or
AN-102.
to Prevent Accidental ptoge of tt» Receiving Station
Press the KEY PROTECT >-» button. The <>-■ mark is displayed,
indicating that all the functions of the buttons are locked. You can
adjust the tone and volume even if the o-« mark is displayed. To
release the key protection, press the KEY PROTECT o-« button
again.
•: To Usellie dhM Ih a bimiy Lighted Area
Press the LIGHT button, (o^ should not be displayed.) The display
window will be illuminated for about 20 seconds.
33