Sony STR-D711 - Manual (Page 14)

Receiving Broadcasts
Tuning in a Station Directly (Direct Tuning)
I POWER-»- on ]
1
Press TUNER.
TUNER
TUNER frequency appears on the display.
Select FM or AM.
FM/AM
“6
Press DIRECT.
DIRECT
15
4
Enter the frequency.
Eizi mz] nzzi i^zi [^zi [izzi I
b
The entered frequency is displayed.
Example 1: FM 102.50 MHz Example 2: AM 1350 kHz
02.BOMHi dE'UKHi
14
To correct the entered frequency
Repeat steps 3 to 4.
For entering AM frequencies
You need not enter the last *0*. (Except for Australian
model)
However, if you have changed the AM tuning interval to 9
kHz, enter all the digits.
If you enter a frequency not covered by the tuning
Interval
The entered value is automatically rounded up or down to
the closest value covered by the tuning interval.
Tuning intervals for direct tuning are the followings:
FM: 50 kHz interval
AM: 10 kHz interval (changeable to the 9 kHz interval)
(See page 5)
9 kHz interval only for Australian model.
When the entered frequency does not exist in the
receivable frequency range
The entered digits blink as follows in the frequency display
area, and reception does not take place.
U.S.A. and Canadian models:
Up to 5 digits for FM or up to 3 digits for AM
Australian model:
Up to 5 digits for FM or up to 4 digits for AM
if this occurs, press DIRECT again, and enter the correct
frequency. The frequency range of the receiver is 87.50 to
108.0 MHz for FM, and 530 to 1710 kHz (U.S.A. and
Canadian models) or 531 to 1602 kHz (Australian model) for
AM.
When an FM stereo program is noisy
When the unit receives an FM stereo program, the STEREO
indicator lights on the display. If the stereo program is noisy,
press FM MODE to change ttie mode over the MONO. This
eliminates the stereo effect, but the noise will be greatly
reduced.
To return to the stereo mode, press FM MODE again.