Note, Notes – Sony TC-WE435 User Manual
Page 8
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Advanced Playback Operations
Locating a Track (Multi-AMS/
Auto Play/Memory Play)
You can locate the following/previous tracks within a
range of 30 tracks (Multi-AMS: Automatic Music
Sensor) or the beginning of a tape quickly (Auto Play).
You can even locate a specific point anywhere on a
tape (Memory Play).
</►*• c/o
Note
Check the direction indicator of the deck you use. When you
locate a track on the reverse side (when <1 lights up), press
the button(s) in the parentheses.
To locate
Press
The beginning of the
next or succeeding
tracks
(Multi-AMS)
►►'(or ◄◄) as many times as you
want during playback.
For example, to locate _2 tracks
ahead, press twice.
The beginning of the
current track
(Multi-AMS)
◄◄ (or ►►) once during playback.
The beginning of the
preceding tracks
(Multi-AMS)
(or ►►) as many times as you
want during playback.
For example, to locate 2 tracks
behind, press three times.
The beginning of a tape
(Auto Play)
MEMORY on the deck being used
repeatedly until "M" disappears in
the display. Then press -4^ (or ►►)
while holding down O (or <]).
A particular point on a
tape (Memory Play)
MEMORY on the deck being used
repeatedly until "M" appears in the
display. Find the point you want,
then press RESET to reset the tape
counter and to memorize the point.
To locate the memorized point and
start playback, press (or ►►)
while holding down O (or <1).
(Press or ►► to stop at "0000." )
Notes
• The Multi-AMS function may not work correctly if:
— the blank space between tracks is less than 4 seconds
long.
— there is a passage of low frequencies or very low
volume within a track.
— the signal strength of the left and right channels are
very different.
• The Multi-AMS function is inoperative on a deck
whenever the other deck is playing, recording (except
during dubbing), or in pause.
• E\ en if the DIRECTION MODE selector is set to C!:^, the
deck stops when the current side reaches the end during
Multi-AMS operation.
• The tape counters are reset to "0000" when you turn off
the tape deck.