Cobra Electronics 25 WX NW ST - Manual (Page 13)

Home And Office Setup
25 24
Base Station
Operation
(From 120V AC
House Current) Base Station Operation
(From 120V AC House Current)
To operate your transceiver from home or offic e
you will need a 13.8 volt DC Power Pack rated at a
minimum of 2 amps, and a properly installed base
station antenna.
Warning!
Do not attempt to operate this
transceiver by connecting it
directly to 120 vac.
Note
For further information call
Cobra Customer Service
1.773.889.3087.
1 Simply connect the red (+) and black (-)
leads of the transceiver to the corresponding
terminals of the power pack.
Temporary Mobile Set-Up
Temporary
Mobile Set-Up
Temporary Mobile Operation
For temporary mobile operation you may want to
purchase an optional cigarette lighter adapter
from your COBRA dealer. This adapter and a mag-
netic mount antenna allow you to quickly “install”
your transceiver for temporary use.
Connect properly installed and matched base
station antenna.
Plug power cable into back of unit marked
“Power”. Be sure to observe polarity markings.
2
3
25 WX NW ST Manual 3.3 6/15/99 1:10 PM Page 24