Cobra Electronics 25 WX NW ST - Manual (Page 8)

When switched to NB position the RF Noise
Blanker is activated, providing increased noise
filtration.
When switched to OFF position Noise
Blanking Filtration will be turned off.
Operation Operation
15 14
NB, OFF
(Noise Blanker )
Switch Dim/Dyna
Control Dim Control
Note
The RF noise blanker is very
effective in reducing repetitive
noises such as ignition interfer-
ence.
NB, OFF (Noise Blanker) Switch
1
Note
The Dim controls the brightness
of the front panel,signal strength
meter and channel display.
Setting Dynamike
This controls the microphone sensitivity
(outgoing audio level).
Setting
Dynamike
1 Initially, set fully clockwise so that maxi-
mum voice volume is available. Dynamike
may have to be reduced in some conditions .
Rotate the DIM knob clockwise for
maximum brightness; counter-clockwise
for minimum. 1
ANL (Automatic
Noise Limiter)
Switch ANL (Automatic Noise Limiter) Switch
When switched to CB/ANL the Automatic
Noise Limiter is activated. This helps reduce
noise created by the vehicle’s electronics. 1
25 WX NW ST Manual 3.3 6/15/99 1:10 PM Page 14