Sony SLV-M91HF - Manual (Page 39)

Basic editing
(when recording on this
VCR)
II PAUSE
m
□
□ t
] ca
o a a a o o g n a
M
IREC
"L2"
Before you start editing
• Turn on your TV and set it to the
video channel.
• Press INPUT SELECT to display ‘
(or "LI") in the display window.
• Press SP/EP to select die tape speed, SP or EP.
• On this VCR, press EDIT to display "EDIT" in the display window. If
the other VCR has a similar button, press it to activate edit function.
Insert a source tape with its safety tab removed into the other
(playback) VCR. Search for the point to start playback and set it to
playback pause.
Insert a tape into this (recording) VCR. Search for the point to start
recording and press
II PAUSE.
Press • REC on this VCR and set it to recording pause.
To start editing, press the II PAUSE buttons on both VCRs at the same
time.
3
4
To stop editing
Press the ■ STOP buttons on both VCRs.
Tip ,
• To cut out unwanted scenes while editing, press II PAUSE on this VCR when an
unwanted scene begins. When it ends, press II PAUSE again to resume recording.
Note
• If you start recording following the procedure above, the VCR won't start recording
with the APC function. To record a tape with the APC function, press # REC again
during recording pause in step 3 so that the VCR analyzes the tape. Then when you
start recording in step 4, press II PAUSE immediately after the APC indicator stops
flashing. If you press II PAUSE before the APC indicator stops flashine. the APC
function is canceled.
Editing 39