Trouble check – Sony CCD-TRV95 User Manual
Page 99
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Trouble check
I
Symptom
Cause and/or Corrective Actions
A vertical band appears when a
subject such as lights or a candle
flame is shot against a dark
background.
• The contrast between the subject and background is too
high. The camcorder is not malfunctioning.
Change locations.
A vertical band appears when
shooting a very bright subject.
• The camcorder is not malfunctioning.
The playback picture is not clear.
• EDIT is set to ON in the menu system.
Set it to OFF. (p. 30)
The picture is ''noisy".
• The video heads may be dirty.
Clean the heads using the Sony V8-25CLH/V8-25CLD
cleaning cassette (not supplied), (p. 90)
The picture does not appear in the
viewfinder.
• The LCD panel is open.
Close the LCD panel, (p. 17)
An unknown picture is displayed in
the viewfinder or on the LCD screen.
• If 10 minutes elapse after you set the POWER switch to
CAMERA without ini jrting a cassette, the camcorder
automatically starts the demonstration or DEMO is set ON
in the menu system.
Insert the cassette and the demonstration stops.
You can deactivate the demonstration, (p. 33)
The picture does not appear on the
LCD screen.
• Incorporated fluorescent tube is worn out.
■>
Please contact your nearest Sony dealer.
The five digit code appears.
• The self-diagnosis function is activated.
Check the code and solve the problem, (p. 97)
Picture is recorded in incorrect/
unnatural color.
• NIGHTSHOT is set to ON.
Set it to OFF. (p. 39)
Others
Symptom
Cause and/or Corrective Actions
The supplied Remote Commander
does not work.
•
COMMANDER is set to OFF in the menu system.
-> Set it to ON. (p. 30)
•
Something is blocking the infrared rays.
■>
Remove the obstacle.
•
The batteries are not inserted with the correct polarity.
Insert the batteries with the correct polarity, (p. 104)
•
The batteries are dead.
Insert new ones. (p. 104)
The picture from a TV or VCR does
not appear even when the camcorder
is connected to outputs on the TV or
VCR.
• DISPLAY is set to V-OUT/LCD in the menu system.
Set it to LCD, (p. 30)
The beep sounds for 5 seconds.
•
Moisture condensation has occurred.
Remove the cassette and leave the camcorder for at least
1 hour. (p. 89)
•
Some troubles occur in your camcorder.
■> Remove the cassette and insert it again, then operate the
camcorder.
96