Sony STR-D665 - Manual (Page 11)

POWER MASTER VOLUME
1 Press POWER to turn on the receiver.
2 Press TUNER.
The last received station is tuned in.
3 Press BAND to select EM or AM stations.
4 Press DIRECT.
5 Press the numeric buttons to enter the frequency.
Example 1: FM 102.50 MHz Example 2: AM 1350 kHz
1 1 1 1 0 1 1 2 11 5 I Po I (You don't have to enter
the last "0.")
fc b to fe &
to to to
6 When you tune in AM stations, adjust the direction
of the AM loop antenna for optimum reception.
To receive other stations
Repeat Steps 3 to 5.
'Q' If the STEREO indicator remains off
Press FM MODE when an FM stereo broadcast is received.
'Q' If an FM stereo program is distorted
The STEREO indicator flashes. Press FM MODE to change
to monaural (MONO). You will not have the stereo effect
but the distortion will be reduced. To return to stereo
mode, press this button again.
If you cannot tune in a station and the entered
numbers are flashing
Make sure you've entered the right frequency. If not,
press DIRECT and re-enter the frequency you want.
If the entered numbers still flash, the frequency is not used
in your area.
To watch FM simulcast TV programs
Make sure that you tune in the simulcast program both on
the TV (or the VCR) and on the receiver.
'Q' If you enter a frequency not covered by the tuning
interval
The entered value is automatically rounded up or down to
the closest covered value.
Receiver Operations
Tuning intervals for direct tuning are:
FM: 50 kHz intervals
AM: 10 kHz intervals (to change to 9 kHz intervals, see
page 16)
Receiving broadcasts by scanning stations
(automatic tuning)
If you don't know the frequency of the radio station
you want, you can have the receiver scan all the
receivable stations to locate the one you want.
1 Press TUNER.
The last received station is tuned in.
2
3
Press BAND to select FM or AM.
Press TUNING + or -.
Press the + button for a higher station number;
press the - button for a lower one. When you tune
past either end of the band, the receiver
automatically jump« to the opposite end. Every time
a station is received, the receiver stops scanning. To
continue scanning, press the button again.
Presetting Radio Stations
You'll most likely want to preset the receiver with the
radio stations you listen to often so that you don't have
to tune in the station every time. The receiver can store
a total of 30 FM or AM stations. You can store the
stations on preset numbers combining 3 characters (A,
B, C) and numbers (0 - 9), For example, you can store a
station as preset number Al, B6 or C9, etc.
Numeric buttons MEMORY
1 Press TUNER.
The last received station is tuned in.
Tune in the station you want.
If you are not familiar with how to tune in a station,
see "Receiving Broadcasts" on the previous page.
(continued)
I
11