Craftsman 917.270822 - Manual (Page 13)

The operation of any tractor can result in foreign objects thrown into the
eyes, which can result in severe eye damage. Always wear safe^ glasses
or eye shields while operating your tractor or performing any adjustments
or repairs. We recommend a wide vision safe^ mask over spectacles, or
standard safety glasses.
_______
HOW TO USE YOUR TRACTOR
TO SET PARKING BRAKE
Your tractor is equipped with an operator
presence sensing switch. When engine is
running, any attempt by the operator to
leave the seat without first setting the
parking brake will shut off the engine.
* Depress clutch/brake pedal into full
“BRAKE” position and hold.
• Place parking brake lever in “EN­
GAGED” position and release pressure
from clutch/brake pedal. Pedal should
remain in “BRAKE” position. Make sure
parking brake will hold tractor secure.
Attachment Clutch
Lever“Engaged”
Position
Throttle
Control
Height
Adjustment
Knob
“Brake”
Position
Choke
Control
“Disengaged"
Position
Parking Brake
"Engaged"
Position
Motion Control
Lever
“Disengaged”
Position
Clutch/Brake
Pedal “Drive"
Position
STOPPING
MOWER BLADES -
• To stop mower blades, move attach­
ment clutch lever to "DISENGAGED”
position.
GROUND DRIVE -
• To stop ground drive, depress clutch/
brake pedal into full “BRAKE” position.
• Move motion control lever to neutral (N)
position.
IMPORTANT: The motion control lever
does not return to neutral (N) position
when the clutch/brake pedal is de­
pressed.
ENGINE- ,
• Move throttle control to slow position.
NOTE: Failure to move throttle control to
slow position and allowing engine to idle
bbfore stopping may cause engine to
“backfire".
.
• Turn ignition key to “OFF position and
remove key. Always remove key when
leaving tractor to prevent unauthorized
use.
• Never use choke to stop engine.
IMPORTANT: Leaving the ignition switch
in any position other than “OFF” will
cause the battery to be discharged,
(dead).
NOTE; Under certain conditions when
tractor is standing idle with the engine
running, hot engine exhaust gases may
cause ""browning” of grass. To eliminate
this possibility, always stop engine when
stopping tractor on grass areas.
ACAUTION; Always stop tractor com-
^tely, as described above, before leav­
ing the operator's position; to empty grass
catcher, etc.
THROTTLE CONTROL
Always operate engine at full throttle.
• Operating engine at less than full
throttle reduces the battery charging
rate.
• Full throttle offers the best bagging and
mower performance.
CHOKE CONTROL
Use choke control whenever you are
starting a cold engine. Do not use to start
a warm engine.
• To engage choke control, pull knob out.
Slowly push knob in to disengage.
TO MOVE FORWARD AND BACKWARD
The direction and speed of movement is
controlled by the motion control lever.
• Start tractor with motion control lever in
neutral (N) position.
• Release parking brdke and clutch/
brake pedal.
• Slowly move motion control lever to de­
sired position.
TO ADJUST MOWER CUTTING HEIGHT
The cutting height is controlled by turning
the height adjustment knob in desired di­
rection.
• Turn knob clockwise (<><) to raise cutting
height.
• Turn knob counterclockwise (r^) to
lower cutting height.
The cutting height range is approximately
1 -1/2" to 4 . The heights are measured
from the ground to the blade tip with the
engine not running. These heights are
approximate and may vary depending
upon soil conditions, height of grass and
types of grass being mowed.
13