HP 730 - Manual (Page 85)

.... Message
i
Possible cause
1
Solution ..........
Focus too dose ; The focus Set the cameia to ■
i distance is closer focus, or if set to
1
,
i than the camera i focus, move further away
i can focus.
1
!
1
Ifrom the subject. See
1 Using macro mode
on
i page 36.
Unicnown USB 1 The camera is i Make sure that the camera
device i connected to a i is connected to a
i USB device that it i supported printer or
i does not
i computer.
1 recognize.
Llnotale to 1 There is no ¡Make sure the cable is
common icote with I connection ¡connected between the
printer i between the ¡camera or HP 8886
1 camera and ¡camera dock and the
1 printer. ¡ printer. If that does not
¡work, turn off the camera
¡and disconnect it. Turn the
1 ¡ printer off and then on
¡again. Re-connect the
¡camera and turn it on.
i A supported ¡Make sure the camera is
! printer is either ¡connected to a supported
1 turned off or not ¡ printer and that the printer
i connected to the i is turned on.
! camera.
i
■! L
1
Print size is larger ¡ Change either print size or
F 1 ■!, I,'.! i than paper size ¡ paper size in the Print
selected paper in the "'irint Setup ¡Setup menu.
size i menu.
i
chapter 7: Troubleshooting and support 87