Install all accessory boards, Raise the system board, Install accessory boards – HP Netserver L Server series User Manual
Page 15
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Advertising
Chapter 1
Installation Overview
Install All Accessory Boards
Raise the System Board
If you are installing accessory boards in slot 5 or 6, raise the system board (if it is
not already raised) to provide easier access to those accessory board slots. To raise
the system board, use the retaining latches to start lifting the system board. Grasp
the metal bracket at the top of the system board, and lift the system board straight
up until its top extends about 5 inches (about 12 cm) above the top of the chassis,
as shown in Figure 1-4. Stops automatically hold it in this position.
Retaining Latch
Typicai
Slot Cover
Advertising