HP Netserver L Server series - Manual (Page 53)

Chapter 6 Troubleshooting
To clear the system configuration:
1. Turn off power to the HP NetServer, and unplug the power cord. Remove
the front bezel and top cover.
2. Refer to Figure 6-1 and the Technical Reference Label inside the top cover,
and move the configuration memory switch, switch 5 on the system board,
to the "ON 2 CLEAR CONFIG" position.
3. Plug in the power cord, and turn on power to the HP NetServer. The
message
Configuration has been cleared, set Clear Config
switch to the OFF position before rebooting
is displayed.
4. Turn off power to the HP NetServer, and unplug the power cord.
5. Return switch 5 on the system board to the OFF position.
6. Replace the top cover and front bezel, and plug in the power cord.
7. Turn on power to the HP NetServer. The error message
0012-34 : Incorrect System Configuration
is displayed. It is followed by the explanation
The BIOS has detected a serious problem that
prevents your PC from booting
This is normal.
8. Press the F2 key to run the Setup utility.
9. Make any configuration changes that are required.
10. Press theFlO function key and answer 'Yes" to save the configuration and
exit the Setup utility.
Hardware Problems
This section describes what to do if you have problems with your display, mass
storage devices, printer, accessory boards, keyboard, or mouse.
The Display Does Not Work
NOTE If the HP NetServer has a large amount of memory installed, it
may take one minute for the first screen to display.
47