Tractor connector, Maintcnancl mindek – Craftsman 132.24607 User Manual
Page 10
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
•
Locate BLACK supply tube from power
unit and BLACK supply tube from misting
nozzle assembly.
•
Remove protective caps from the BLACK
supply tube and filter attached to the
BLACK tube.
•
Connect BLACK supply tube from misting
arm assembly to the filter installed on the
BLACK supply tube from the power unit.
Continue to push supply tube over the
barb on the filter until it rests against
the filter body.
step 3
NOTE: The supply tube may be difficult to
assembly to the filter body. Wiping the barb
with water may facilitate assembly.
•
Locate BLUE supply tube from power unit
and BLUE supply tube from misting arm
assembly.
•
Remove protective caps from the BLUE
supply tube and filter attached to the
BLUE tube.
•
Connect BLUE supply tube from misting
arm assembly to the filter installed on the
BLUE supply tube from the power unit.
Continue to push supply tube over the
barb on the filter until it rests against
the filter body.
Connecting Power Unit to Tractor
Electrical System
Step 1
• Look on the dash of your tractor and deter
mine whether your tractor is equipped with
a Maintenance Minder. If your tractor is
not supplied with a Maintenance Minder,
proceed to step 12.
MAINTCNANCL
miNDEK
Step 2
• From inside the engine compartment,
locate the underside of the Maintenance
Minder.
TRACTOR
CONNECTOR
Disconnect tractor electrical connector
from Maintenance Minder.
10