Craftsman 132.24607 - Manual (Page 7)

Using supplied 9/16" drill bit (DD), drill hole
through the dash at the bottom of the
mounting location. Use caution not to
damage anything in the engine com­
partment while drilling hole.
• Install rubber washer (H ) onto the misting
arm assembly (BB), by sliding over hoses
and threaded section until seated against
mounting flange.
Step 2
• Proceed to Step 2.
Step 1b (Tractors w/o mounting locations)
• Open tractor hood and ensure that no
wires or cables are located at the bottom
of potential mounting locations. If wires or
cables are present, temporarily clear the
area by securing them safely away from
mounting location using a supplied cable
tie (J).
• Evaluate dash for best location to mount
misting arm. Ensure that the chosen loca­
tion will not limit the functionality of the
tractor or interfere with closing of the hood.
• Mark desired location.
• Prior to drilling, take precautions to protect
engine compartment from drill shavings.
• Using supplied 9/16" drill bit (DD), drill hole
through the dash at the desired mounting
location Use caution not to damage
anything in the engine compartment
while drilling hole.
• Remove drill shavings and clean area
surrounding mounting location.
• Proceed to Step 2.
• Feed supply lines of nozzle holder assem­
bly (BB) through hole drilled in step 1 .
From inside the engine compartment, pull
supply lines through hole until the flange of
the misting nozzle assembly (BB) is
seated on the surface of the dash.
Threaded portion of adapter should now
extend into the engine compartment at
mounting location.
-
W - • '
....... ... .....
I i 4
_