Craftsman 132.24607 User Manual
Page 15
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
HOW TO START YOUR RIDER
COOLING SYSTEM
•
With the tractor key in “ON" position,
toggle power switch on unit to “ON" posi
tion.
NOTE; It is normal to experience a delay from
the time the system is turned on to the deiiv-
ery of mist from the nozzle. If this exceeds 2
minutes, refer to the troubleshooting section.
HOW TO STOP YOUR RIDER
COOLING SYSTEM
•
Toggle power switch on unit to “OFF”
position.
NOTE; The system will continue to mist after
the system is turned off. The system will stop
misting after the water and air lines have been
cleared.
HOW TO REFILL YOUR RIDER
COOLING SYSTEM
•
Switch power switch on power unit to the
“OFF” position.
•
Allow system to vent. System is ready
to fill when air can no longer be heard
coming from misting head.
•
Remove fili cap on power unit and fill
through basket filter with DRINKING
WATER ONLY .
•
Replace cap and hand tighten.
ADJUSTING MIST DENSITY
•
To optimize the cooling effectiveness of
the system, the adjustment valve offers
unlimited variation of mist density from
closed to fully open.
•
To increase the mist density, turn valve
counterclockwise.
•
To decrease the mist density, turn valve
clockwise.
•
Once you are satisfied with the setting of
your mist density, use the locking nut on
the adjustment valve to save your setting.
OPERATING TIPS
•
Never use any liquid other than
DRINKING WATER in the system.
•
For dry climates, increasing the water
flow will provide maximum cooling re
sults. In humid climates, a reduced water
flow is recommended.
•
Adjust the misting nozzle direction to
maximize contact with exposed skin
during operation.
15