Assembly, Installing the front table – Craftsman 315.220380 User Manual

Page 32

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

ASSEMBLY

INSTALLING THE FRONT TABLE

See Figures 23A - 23C.

Use this procedure to install the fixed front table.

The top of the table has counterbored holes, predrilled
from the top, around the center to attach the table. In
the center are a counterbored hole and a small hole,
which is not counterbored. They are used for raising
or lowering the center of the table until it is level.

■ Locate the front table and the following hardware:

1 tee nut
1 U-clip (1/4 in.)
1 setscrew (1/4-20 x 7/8 in.)

4 pan head screws (1/4-20 x 1 in.)

1 pan head screw (1/4-20 x 1-3/4 in.)

5 flat washers (5/8 in.)
4 lock washers (1 /4 in.) '

4 hex nuts (1/4-20)

■ Place the front table on a solid worksurface, with

the top surface face down. Place the tee nut in the

non-counterbored hole and tap it in place with a
hammer.

SETSCREW

Snap the U-cItp onto the front edge of the saw
base. Line up the hole in the U-clip with the saw
base hole just to the left of the center notch in saw
base. See

Figure 23B.

Place the table, top up, on the table supports so the

center counterbored hole lines up over the hole in
the U-clip.

Place a flat washer in each counterbored hole.

Place the long pan head screw into the center hole
and thread into the U-clip. Do not tighten until the

table has been checked for evenness.

See Figure

23A.

Place the setscrew through the small leveling hole

and thread into the tee nut, but do not tighten.

Put a 1 in. long pan head screw in the four remain­
ing holes and through the holes in the support.

Cap with a lock washer and hex nut. Tighten with a
7/16 in. wrench and phillips screwdriver. This
completes installation of the front table.

SETSCREW

Fig. 23C

CRRFTSMRir

RADIAL SAW 315.220380

32

Advertising