Operation, Non-through cuts – Craftsman 315.220380 User Manual
Page 53
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
OPERATION
NON-THROUGH CUTS
See Figure 49.
VV WARNING:
Unplug the saw while removing or
replacing the blade guard. Turn on the saw with
the switch on the arm to confirm the blade is not
receiving power.
■ Remove the blade and blade guard (see
Assembly
section).
■ Place a support the same height as the saw table
nearby for the cut work. Lower the blade with the
elevating handwheel.
■ Make sure the wood is not touching the blade.
Insert the key and turn on the saw. Let the blade
build up to full speed before contacting the work
piece.
WARNING:
Always use pushblocks when
making non-through rip cuts to avoid the risk of
serious injury. Never feed wood with your hands.
■ When the work is completed, press the switch off
and remove the key.
NON-THROUGH CUT
Fig. 49
53
MRFTSMflir RADIAL SAW 315.220380