Craftsman 486.24515 - Manual (Page 10)

• Set the cart right side up on its wheels and place a
corner cap over each front corner of the cart as
shown in figure 13.
• Assemble front panel over the ends of the side panels
and on top of the cart bed flange and the comer caps.
Leaving the top holes in the front panel empty, fasten
it to the cart body and the side panels using six 1/4"
X 3/4“
hex bolts, six 1/4" flat washers, six 1/4“ lock
washers and six 1/4" hex nuts. See figure 15.
• Position the right side panel on top of the cart bed
flange and the front comer cap. Align holes in side
panel with holes in corner cap and holes in top of cart
bed flange. Fasten together using two 1/4“ x 3/4" hex
bolts, two 1/4" flat washers, two 1/4“ lock washers and
two 1/4“ hex nuts. Repeat on other side. See figure 14.
Assemble the cross brace to the two top holes at the
rear of each side panel using four 1/4" x 3/4" hex
bolts, four 1/4" lock washers and four 1/4“ hex nuts.
See figure 16.
10