Craftsman 486.24515 - Manual (Page 11)

Install the poly hard top over the front and side panels.
Fasten using fourteen 1/4" x 3/4" hex bolts, 1/4“ flat
washers, 1 /4" lock washers and 1 /4" hex nuts. See
figure 17.
Assemble the five clamps onto the cart flanges,
placing one in front center and two on each side,
positioned approximately 12" from each end. Use a
3/8“
X 1-1/2“ hex bolt to secure each clamp from the
bottom. See figure 17.
• Assemble a door latch at each end of the cross brace
using a 5/16“ X 3/4* hex bolt, a nylon washer and a
5/16" hex lock nut. Place nylon washer between door
latch and cross brace. Tighten so that latch is snug
but will still rotate. See figure 18.
• Assemble door support brackets underneath the rear
of the cart bed by removing the hex nuts from the
bolts shown in figure 18. Fasten the brackets to the
cart using the same hex nuts which were removed.
Assemble one short tie strap to each side of rear door
using one 1/4" x 1 -1/4” hex bolt, two 1/4" flat washers,
one 1/4” lock washer and one 1/4“ hex nut. Assemble
an "S" hook through the loose end of each strap. See
figure 19.
Assemble a 1 /4” x 1" hex bolt with a 1 /4* hex nut to
outside of hole on each side of cart bed and secure
from inside with a 1/4“ lock washer and a 1/4" hex
nut. See inset in figure 19.
Assemble door to rear of cart by resting bottom of
door on door support brackets and rotating top of door
forward to meet cross brace. Latch top of door on
each side. See figure 19.
Hook both the tie straps onto the 1/4* x 1 “ hex bolts
which were just assembled. See figure 19.
11