Craftsman 486.24515 User Manual
Page 12
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Assemble the engine base assembly to the welded
angles on the tongue using four 5/16" x 3/4" hex bolts,
5/16" lock washers and 5/16" hex lock nuts. NOTE:
Use the upper set of holes in the welded angles.
Make sure bolts are securely tightened. See figure 20.
Mount the chipper chute assembly onto the three
weld bolts located on the back side of the blower
housing assembly. Fasten with three 5/16" bell
washers (cupped side against chute assembly) and
three 5/16" lock nuts. Tighten securely. See figure
22
.
To assemble the hose hanger bracket to the blower
housing, you must first remove two self tapping
screws from the holes in the blower housing as shown
in figure 21. Using these same screws, attach the
hose hanger bracket to the blower housing.
Assemble the elbow to the blower housing, using four
5/16" X 3/4" seif tapping hex bolts, and four nylon
washers. Tighten bolts securely. See figure 23.
12