Craftsman 486.24515 - Manual (Page 9)

• Assemble the front tongue over the top of the rear
tongue using three 3/8" x 3" hex bolts, 3/8" lock
washers and 3/8" hex lock nuts. See figure 8.
Assemble the hitch bracket to the front tongue using
two 3/8“ X 1-1/4" hex bolts, 3/8" lock washers and 3/8”
hex nuts. Tighten. See figure 9.
• Position the tongue on the bottom of the cart as
shown in figure 11. Assemble the axle through the
wheel support and the tongue. Fasten the axle to
the wheel support using two 1/4“ x 1-3/4" hex bolts
and 1/4" hex nuts (SEMS). Tighten.
IMPORTANT: Make sure the tongue is securely locked
to the latch stand bracket by the latch lock assembly.
Assemble the latch lock assembly to the tongue using
two 1/4" x 2-3/4" hex bolts, two 1M" lock washers and
two 1/4" hex nuts. Fasten to the two front holes in the
forward grouping of four holes as shown in figure 10.
Assemble the angle stop to the tongue using two 1/4“
X 2-3/4" hex bolts, two 1/4" lock washers and two 1/4"
hex nuts. Fasten to the two front holes in the rear
grouping of four holes as shown in figure 10,
Assemble a spacer tube onto each end of the axle as
shown in figure 12.
Assemble a flat washer, a wheel {valve stem facing
out), and another flat washer onto the axle as
shown in figure 12. Secure the wheel with a cotter
pin, spreading the ends so that a hub cap can fit
over the pin. Assemble the hub cap by pressing it
onto the flat washer. Repeat on other end of axle.
FIGURE 10