Canon 540EZ User Manual
Page 44
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Rotate the flash head upward to
the vertical 90° position, then pull
the wide panel out of its housing
until it locks in place at the click
position. After that, the procedure
is the same as for normal bounce
flash photography.
The catchlight effect will not be
produced if the flash head is
rotated to the left or right. The
catchlight panel should only be
used with the flash head In the
90° upward bounce position.
To effectively produce the catch
light in the subject’s eyes, make
sure the subject is within 1.5m
!
5ft from the camera
If the flash head is angled 7° down
ward while the wide panel is set to
the catchlight position, the entire LCD
panel will blink to warn you that the
bounce position is incorrect. Rotate
the flash head to the 90° upward
bounce position.