Setting of voltage, Preparations for projection – Canon P 400 User Manual
Page 10
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Setting of Voltage
Before using Canon Cine Projector P-400, be sure to set
the voltage
sw
tch at the voltage to be used. The fuse
\A/ill blow out or the motor will not function if the voltage
is not properly set.
To change the voltage, turn the voltage switch inside the
voltage indicator window with a screwdriver until the
desired figure appears.
Preparations for Projection
1
When loading the film check the end of the film. In
* case the film is bent or any foreign substance is no
ticed on the f Im, cut this section with the film cutter
separately supplied.
O Set the film selector. Press down the lever of the film
^ selector so that it shows "S” matching the red dot in
front when projecting Super 8 or Single 8 film. In case
of regular 8mm film, pull up the lever to show "R” instead.