Pre-adjusting for projection – Canon P 400 User Manual
Page 13
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Pre-Adjusting for Projection
The power switch of the projector is 4-way system. When
turned to the red dot, the motor is on: and starts func
tioning by turning to "FWD. & REW”. The lump lights
up by turning the switch knob to "LUMP”. Do not turn
the switch knob abruptly.
1
Set up the projection screen.
2
Remove the lens cap.
3
Turn the switch knob to "LAMP" to see whether the
picture is projected properly onto the screen evenly
illuminated.
k
Make the height adjustment by turning the angle "ad-
' justing leg.
C Determine the projection size by rotating the lens
^
barrel of the zoom lens.
C Adjust the focus by turning the focusing knob until the
^ frames of the projected beam become sharp.