Carrier Access Access Navigator - Manual (Page 305)

Access Navigator - Release 1.8 August 2003 13-9
Provision Remote Adit 600 via IP DS0
Verify Equipment Configuration
A message similar to the following will appear, showing the link up/down service status of all
DS1s in the Access Navigator, as well as certain other parameters of common interest in provision-
ing and trouble-shooting.
Remote
Line Term Device
Circuit ID Link Type Code Framing ID FDL Mgmt
---------- ---- ------ ---- ------- ---- ----- ------
CA DS1# 01 DOWN DROP B8ZS ESF None CA IP
CA DS1# 02 DOWN DROP B8ZS ESF None None
CA DS1# 03 DOWN DROP B8ZS ESF None None
CA DS1# 04 DOWN DROP B8ZS ESF None None
CA DS1# 05 DOWN DROP B8ZS ESF None None
CA DS1# 06 DOWN DROP B8ZS ESF None None
CA DS1# 07 DOWN DROP B8ZS ESF None None
CA DS1# 08 DOWN DROP B8ZS ESF None None
CA DS1# 09 UP DROP B8ZS ESF None CA FDL
CA DS1# 10 UP DROP B8ZS ESF None CA IP
CA DS1# 11 DOWN DROP B8ZS ESF None None
CA DS1# 12 DOWN DROP B8ZS ESF None None
CA DS1# 13 DOWN DROP B8ZS ESF None None
CA DS1# 14 DOWN DROP B8ZS ESF None None
CA DS1# 15 DOWN DROP B8ZS ESF None None
CA DS1# 16 UP DROP AMI D4 None None
CA DS1# 17 UP DROP AMI D4 None None
CA DS1# 18 UP DROP B8ZS SLC96 None SLC96
CA DS1# 19 UP DROP B8ZS SLC96 None None
CA DS1# 20 UP DROP B8ZS ESF T1403 None
CA DS1# 21 DOWN DROP B8ZS ESF None None
CA DS1# 22 DOWN DROP B8ZS ESF None None
CA DS1# 23 DOWN DROP B8ZS ESF None None
CA DS1# 24 DOWN DROP B8ZS ESF None None
CA DS1# 25 DOWN SWITCH B8ZS ESF 1 None None
CA DS1# 26 DOWN SWITCH B8ZS ESF 3 None None
CA DS1# 27 DOWN SWITCH B8ZS ESF 4 None None
CA DS1# 28 DOWN SWITCH B8ZS ESF 5 None None
CA DS1# 29 DOWN SWITCH B8ZS ESF 2 None None
CA DS1# 30 DOWN SWITCH B8ZS ESF 6 None None
CA DS1# 31 DOWN SWITCH B8ZS ESF 7 None None
CA DS1# 32 UP GROOM B8ZS ESF None None
NOTE: Access Navigator Release 1.7 provides new remote management commands.
For Carrier Access IP DS0 management, the Remote Device Management type must be
set to CA IP and the DS1 FDL type must be set to None.
5. Verify number of DS1s already in service (link is up) by comparing DS1 link status with office
records. If there is a discrepancy, follow standard practices to resolve problem.