Checking the power level of batteries, Loading of film cartridge 1, Unloading of film cartridge – Canon 518 SV User Manual
Page 15: Footage counter
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Checking the Power Level of Batteries
The
power
level
of
the
batteries
can
be
checked
by
turning
the
shutter lock dial to "R", pressing the battery checker and checking
the position in the power level indicator.
If
the
needle
reaches
the
blue
zone,
the
betteries
have
sufficient
power level.
If
the
needle
is
in
the
white
zone,
the
batteries
have
a
power
level only for 24 fps or under.
If the needle is in the red zone, replace all of the batteries.
■ When not using the camera, keep the shutter lock dial at "OFF”.
■ Always check the power level of the batteries before shooting.
■ The film cartridge with following speeds can be used.
Tungsten type : ASA 25, 40, 64, 100, 160, 250, 400
Daylight type : ASA 16, 25, 40, 64, 100, 160, 250
Loading of Film Cartridge
1
Open the rear cover by pressing the rear cover lock button.
O
Slide
the
Super
8
film
cartridge
towards
the
front
of
the
^
camera
with
the
film
gate
facing
ahead.
The
film
speed
is
automatically set with the insertion of the cartridge.
2
Close the rear cover by pressing it.
k
Set
the
shutter
lock
dial
at
"R”.
Pull
the
trigger
to
confirm
”
the
film
advance.
If
you
can
hear
the
sound
of
film
winding
and the white dot in the film transport indicator revolves, it means
the cartridge is properly inserted.
■
The
Super
8
film
cartridge
is
loaded
with
50-foot
film.
There
is
no
need
for
flipping
over
the
cartridge
in
reverse
direction
halfway through the film.
Footage Counter
The
footage
counter
tells
you
how
many
feet
of
film
you
have
exposed.
It
automatically
resets
to
"O"
when
the
cartridge
is
taken out.