Christie Digital Systems 38-DHD103-XX - Manual (Page 9)

Stacking Frame Installation Instructions
013-100342-01 (Rev.1) (08/06) 9 of 12 pages
1. If the projector is inverted retract the adjustable feet to prevent the hoisting
hardware from becoming snagged.
WARNING
Always use at least two safety cables when hoisting.
When hoisting a non-inverted projector or stack, add two rigging eyebolts in the
front and rear threaded holes on the top of the projector. Ensure the eyebolts are
rated adequately for the load. Secure safety cabling to both eyebolts.
2. Attach a safety cable to each of the two eyebolts
mounted on the bottom of the projector. Refer to
Figure 6.
3. Secure the rigging components to the appropriate
rigging points. Eight sliding points are provided on
the bottom of the projector. To prevent sliding
tighten the nut at each required location.
4. Use at least four rigging points (two opposite
sides) and ensure the straps, clamps or cabling
meet the adequate load capacity for the total
projector(s) weight. Refer to Section 6 of the
manual shipped with the projector for information
on size and weight.
DO NOT join the rigging
straps or cables to a common point — keep
separated. Ensure all straps are taut.
Figure 6. Safety Cables
OFFICIALLY RELEASED
Document Control
September 8, 2006