Installation place requirement, Positioning, Bs plug safety details (for u.k. user) – LG F84882WH User Manual
Page 6: Important, Nstallation
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
nstallation
Installation place requirement
Level floor:
Allowable slope under entire washer is 1”
Power outlet:
Must be within 1.5 meters of either side of location of
washer. Do not overioad the outiet with more than one
appliance.
Additional Clearance:
For wall, door and floor modeling is required.
(10cm : rear /2cm:right & left side)
Do not place or store laundry products on top of washer at
any times.
They can damage the finish or controls.
■ Positioning
Install the washer on a flat hard floor.
Make sure that air circulation around the washer is not impeded by carpets, rug etc.
• Never try to correct any unevenness in the floor with pieces of wood, cardboard or similar
materials under the washer.
" If it is impossible to avoid positioning the washer next to a gas cooker or coal burning stove, an
insulation(85x60cm) covered with aluminum foil on the side facing the cooker or stove, must be
inserted between the two appliance.
• The washer must not be installed in rooms where the temperature can drop below 0°C.
• Please ensure that when the washer is installed, it is easily accessible for the engineer in the
event of a breakdown.
• Adjust all four feet using the transit bolt spanner provided ensuring the appliance is stable, and a
clearance of approximately 20mm is left between the top of the washer and the underside of the
work-top.
■ BS Plug Safety Details (For U.K. User)
IMPORTANT
THE WIRES IN THIS MAINS LEAD ARE COLOURED IN
ACCORDANCE WITH THE FOLLOWING CODE:
GREEN AND YELLOW; EARTH
BLUE;NEUTRAL
BROWN; LIVE
This appliance must be earthed
As the colours of the wires in the mains lead of this apparatus may not correspond with the coloured markings identifying
the terminals in your plug, proceed as follows:
The wire which is coloured Green and Yellow must be connected to the terminal in the plug which is marked with the letter E
or by the earth symbol @ or coloured Green or Green and Yellow.
The wire which is coloured Blue must be connected to the terminal which is marked with the letter N or coloured Black.
The wire which is coloured Brown must be connected to the terminal which is marked with the letter L or coloured Red.
If a 13 amp (BS 1363) plug is used, fit a 13 amp BS 1362 fuse.
. 6 B