LG F84882WH - Manual (Page 29)

roubleshooting guide
Symptom Possible Cause
• Water supply is not adequate in area.
• Water supply taps are not completely open.
• Water inlet hose(s) are kinked.
• The filter of the inlet hose(s) are clogged.
• Drain hose is kinked or clogged.
• The drain filter is clogged.
• Load is too small.
• Load is out of balance.
• The appliance has an imbalance detection and
correction system. If individual heavy articles
are loaded (ex. bath mat, bath robe, etc.) this
system may stop spinning or even interrupt
the spin cycle altogether.
• If the laundry is still too wet at the end of the
cycle, add smaller articles of laundry to
balance the load and repeat the spin cycle.
• Is the door opened?
• Water overfills due to the faulty water valve.
• Water level sensor has malfunctioned.
• Over load in motor.
• Over load in motor.
• The washer experienced a power failure.
Solution
Check another tap in the house.
Fully open tap.
Straighten hose(s).
Check the filter of the inlet hose.
Clean and straighten the drain hose.
Clean the drain filter.
Add 1 or 2 similar items to help
balance the load.
Rearrange load to allow proper
spinning
Close the door.
* If “dE ” is not released, call for
service.
Unplug the power plug and call for
service.
Close the water tap.
Unplug the power plug.
Call for service.
Restart the cycle.
29