LG WD-65130F - Manual (Page 21)

aintenance
^ Before cleaning the washer interior, unplug the electrical power cord to avoid electrical
shock to avoid electrical shock hazards.
The water inlet filter
- Rinse+ and Crease Care lamps will blink on the control panel when water does not enter the
detergent drawer.
- If your water is very hard or contains traces of lime deposit, the water inlet filter may
become clogged.
It is therefore a good idea to clean it from time to time.
1. Turn off the
water lap.
3. Clean the
filter using a
hard bristle
brush.
2. Unscrew the
water inlet
hose.
4. Tighten up
the inlet
hose.
■ The drain pump fiiter
^ The drain filter collects threads and small objects left in the laundry.
Check regularly that the filter is clean to ensure smooth running of your machine.
A CAUTiON Rrst drain using the drain and then open the pump filter to remove whatever
any threads or objects.
Be careful when draining if the water is hot.
1. Open the lower cover
cap ((J)) by using a
finger Turn the drain
plug ((gi to pull out
the hose.
2, Unplug the drain plug (©),
allowing the water to flow out. At
this time use a vessel to prevent
water flowing on to the floor. When
water does not flow any more, turn
the pump filter open to the left.
3, Remove any foreign material
from the pump filter ((3;i). After
cleaning, turn the pump filter ({g;)
clockwise and insert the drain
plug (i|))to the original place,
close the lower cover cap.
21