B&M 70360 SHIFT IMPROVER KIT User Manual

Page 6

Advertising
background image

6

12). With the 3-4 Accumulator
components and the case check ball
in place, Place the Separator Plate
and gasket assembly up to the case
followed by the 1-2 Accumulator
Housing assembly. Carefully line up
the gaskets and install accumulator
housing and support plate. Tighten
bolts finger tight ONLY (See Fig. 2).
STEP 15. Make sure Valve Body
check balls are in correct locations
(See Fig. 12). Position the manual
valve so the manual valve link can be
engaged (See Fig. 4). The manual
valve link must be placed into the hole
in the manual valve at a right angle to
valve axis, then rotated 90 degrees to
allow the valve to enter the manual
valve bore. Do not force valve or link
at any time. When the valve is fully
engaged, align the valve body and case
holes and install one bolt finger tight
to hold valve body in place. Refer to
your sketch and notes to properly
position wire harness clips and
solenoid connectors. Install all of the
remaining bolts finger tight to finish
lining up the separator plate and
gaskets (See Fig. 2). Tighten all the
valve body, accumulator and support
plate bolts to 11 Nm (8 Lb. Ft.). Avoid
striped threads. Do not over tighten
bolts.
STEP 16. Double check your
installation;
1: make sure all bolts are installed
and torqued.
2: Wiring harness is properly
connected.
3: Regulator valve retaining ring fully
seated in groove. Coat the filter pickup
tube with clean ATF then push the filter
tube into the pump bore until it is fully
seated.
STEP 17. Remove any old pan gasket
material from pan and case pan rail.
Clean inside of pan with solvent. You
may want to install a B&M Drain plug
kit (80250) at this time. Install the new
Pan Gasket on the pan and align the
holes. Use petroleum jelly to help hold
the gasket in place during installation
of pan. Do not use any gasket sealer
or silicone compounds. To prevent
premature band failure make sure the
vent hole shown in Fig. 2 is not blocked
or obstructed. Place pan up to case,

1994 to 02

1994 to 02

1994 to 01

1994 to 01

Advertising