B&M 70360 SHIFT IMPROVER KIT User Manual
Page 8
8
ERROR CONDITION WHERE TO LOOK FOR CAUSE
High or Low Oil Pressure Oil Pump
~ Pressure Regulator Valve Stuck.
~ P/R Retainnig Ring not fully seated in groove
~ Orifice hole in P/R Boost Valve sleeve plugged.
Oil Filter
~ Cracks in Filter Intake Tube.
~ Intake Tube Seal Damaged.
~ Wrong grease used on reassembly (clogging filter).
Valve Body Assembly
~ Spacer Plate or Gaskets misassembled or damaged.
~ Check Balls omitted or mislocated.
~ Wrong grease used on reassembly (clogging Solenoid
Filter.)
Harsh Shifts
Valve Body Assembly
~ Wrong holes drilled.
~ Separator Plate or gaskets misassembled or damaged.
~ Check Balls omitted or mislocated.
Inconsistent Shift Points Valve Body Assembly
~ Separator Plate or gaskets misassembled or damaged.
External Linkage
~ Manual Shift Lever Linkage misadjusted.
No or Slips in 1st Gear
1-2 Accumulator
~ Damaged or missing piston seal.
~ Incorrect spacer(s) holding piston above case surface.
Low Oil Pressure
~ (See above)
Valve Body Assembly
~ Spacer Plate or gaskets misassembled or damaged.
~ Check Balls omitted or mislocated,
~ Solenoid disconnected or damaged,
~ 2-4 Band Anchor missing
No or Slipping 2-3 Shift
Valve Body Assembly
~ Spacer Plate or gaskets misassembled or damaged.
~ Solenoid disconnected or damaged.
~ Spacer Plate or gaskets misassembled or damaged.
No or Slipping 3-4 Shift
Valve Body Assembly
~ Spacer Plate or gaskets misassembled or damaged.
~ Solenoid disconnected or damaged.
~ Spacer Plate or gaskets misassembled or damaged.
3-4 Accumulator
~ Damaged or missing piston seal,
No or Slipping Reverse
Valve Body Assembly
~ Spacer Plate or gaskets misassembled or damaged.
Oil Pump
~ P/R Retaining Ring not fully seated in groove.
No TCC Apply
TCC Solenoid
~ Solenoid disconnected or wiring damaged.
TOOL LIST
1
3/8" drive ratchet wrench
1
3/8" torque wrench
1
2"-6" 3/8" drive extension
1
8, 10, 13mm Sockets
1
8, 10, 13mm combination wrench
1
8" Plain Screwdriver
1
Small Internal Retaining Ring Pliers
1
Needle nose pliers
1
Hammer
1
Gasket scraper
1
3/8" Drill motor
1
Fine cut fiat file
1
Wet or Dry sand paper
PARTS LIST
1
Pan Gasket
1
Upper Valve Body Gasket
1
Lower Valve Body Gasket
2
Snap in Solenoid Filters Aluminum Plug
1
GREEN Press Regulator Spring
1
Press Regulator Retaining Ring
1
3/8"x 5/16" ID RED Spacer
1
1/2"L x 5/16" ID GREEN Spacer
1
5/8"L x 5/16" ID YELLOW Spacer
1
3/4"L x 5/16" ID BLUE Spacer
1
19/32"L x 1/4" ID VIOLET Spacer
1
3/8"L x 1/4" ID WHITE Spacer
1
3/32" (.094) Drill 1/8" (.125) Drill
1
1/2" x 1" x 2" Anvil Plate