B&M 70360 SHIFT IMPROVER KIT User Manual
Page 7
Advertising
7
align holes and install all bolts finger
tight. Tighten bolts to 12 NM (9 Lb.
Ft.). Do not over tighten bolts. If the
bolts are over tightened the gasket will
deform excessively and result in oil
leaks.
STEP 18. Fill transmission with ATF
to the full mark on dip stick. You will
need about 4 to 6 quarts. We
recommend B&M Synthetic Trick
Shift ATF for Heavy Duty and Street
level applications. With vehicle still off
the ground, start the engine and shift
transmission through all gears.
Check for leaks around oil pan flange
and drain plug. Place selector in
neutral and check the fluid level. Stop
engine and then lower vehicle.
STEP 19. Test drive vehicle and
re-check for leaks while transmission
is hot. Check fluid level again,
adjusting level as required.
Advertising