Salter Brecknell 6712 - Manual (Page 9)

Model 6712 Point-of-Sale Interface Scale User’s Manual 9
Entering Setup Mode
Access the MENU Mode by pressing switch 1
shown in Figure 1.
In the Menu Mode, there are three modes
available. They are as follows:
Diagnostic Mode (DIAG) – Used to test areas of
the scale’s function.
Configuration Mode (CONF) – Used to config-
ure the scale for your application.
Calibration Mode (CAL) – Used when calibrat-
ing the scale.
The structure for these menus is shown in Figure
2. Following that are the step-by-step instructions
for accessing the items within each menu.
Accessing the
Menu Mode
Figure 1
Switch Diagram
Diagnostics Mode
Diagnostic DIAG Mode
The diagnostic (DIAG) mode menu lets you test
specific areas of the unit’s function. These areas
are:
Display (DISP) – Shows the version and revision
of the software, followed by a display segment
test.
Bottom view